Second HDD Hard Drive Upgrade Tools Kit SSD Flex Cable 821-1501-A for Mac Mini A1347. Home / Mac / Mac mini / Unibody (A1347) Low position. RAM: The Mac Mini Mid 2010 can be upgraded to accept a blazing of RAM. Mac mini Unibody (A1347) Replacement Parts. Odyson - Logic Board Removal Tool Replacement for Mac Mini A1347 (Mid 2010-Late 2014) Add to Cart. You can cost-effectively upgrade a number of components in the Mac mini Mid 2010. However, if the HDD has a temperature sensor cable, read the following “ About the HDD temperature sensor cable” and take the necessary measures. SATA Hard Drive Cable 821-1500-A 821-1501-A SSD HDD Upgrade Kit Replacement for Mac Mini A1347 2011 2012. ▶ To assemble an iMac with a replacement HDD, follow the reverse procedure up to this point. ▶︎ After removing the HDD, remove the T8 Torx screws and parts on both sides.
(Some iMa models do not have a temperature sensor cable) ▶ After removing the screws, remove the HDD while removing all the cables connected around the arrows in the figure.Īlthough it is difficult to see in the figure, there are three types: SATA signal cable, power cable, and temperature sensor cable. Remove the two T8 Torx screws shown by the arrows in the figure. ▶ After removing the screws, remove the HDD inside the iMac while tilting the LCD display forward, keeping the iMac upright and taking care not to tip it over. I see that OWC has an 'adapter' thing - sort of like a gasket to increase the 7 mm height to 9.5 mm. Many of the SSDs (the one Ive already ordered) shows a height of 7 mm. I have noticed the drive I took out of it shows a height of 9.5 mm.
▶ As for how to remove the screws, there are some strong magnets nearby, so if you can remove it in a little while, you should pick it up with tweezers or needle-nose pliers. Im looking to put an SSD into my 2010 mini. ▶ With the front glass panel removed, lay the iMac on its side and remove the T8 Torx screws that hold the LCD display in place. To make the memory installation process as straightforward as possible, we provide step-by-step installation. Since the first Mac mini was released in 2006, OWC has offered Apple-compatible memory upgrades for nearly any Mac mini model. ▶ After removing the front glass panel, lean it in a suitable place. All 2020 and later M1 Mac mini models have memory integrated into the Apple M1 chip and cannot be upgraded. The trick is to stick it near the top edge of the glass panel, pull it little by little, and if you get a slight gap, stick your finger in and prevent it from sticking again with the magnet. This glass panel is attached to the iMac itself with many strong magnets, so it won’t come off without a lot of effort. ▶ With the iMac upright, attach the vacuum lifter to the front glass panel and pull to remove it. This is to prevent you from getting an electric shock from the current remaining inside the iMac when you disassemble it, or shorting the board when you roll the screws. ▶︎ Unplug the power cable from your iMac and press the power switch on the back 5-6 times. You can do this for other models in much the same way, but please note that there are some differences. The iMac models used in the explanations below are as follows. Procedure for disassembling iMac and replacing HDD